Printed blasters can be very different than normal blasters, so please read this whole thing before firing!!
#1: Check to make sure nothing was damaged in shipping
Sometimes blasters require a slight adjustment depending on how they arrive. If you notice any cracked parts or dislodged parts, don’t fire until you’ve put them back.
Always email us with any questions! We replace anything damaged in shipping.
#2: Stop firing IMMEDIATELY if no dart comes out
If no dart comes out of the blaster, you might think that pulling the trigger harder and longer will help.
PULLING THE TRIGGER HARDER WILL DAMAGE THE BLASTER!
Stop firing immediately!
If not dart comes out, it’s probably because you have a jam.
Clear the jam, then continue firing 🙂
*If you continue to fire without first clearing the jam, you risk blowing out the motors*
How to clear a jam the easy way:
Remove the magazine.
Look down the barrel or up the magwell to see if you can see a jammed dart.
If so, poke the dart out with a stick or other slender object by inserting the stick or object down the barrel from the front.
The squished dart should fall out the magwell.
You’re good to go!
#3: Get used to the trigger pull before firing rapidly
Half a pull revvs the motors, and a full pull fires the blaster.
Experiment with different levels of pressure on the trigger before firing rapidly.
If you understand how the trigger feels, you’ll be much more likely to get good performance out of your blaster.
#4: Have a TON of fun
The Woozi is such a fun blaster. You’re lucky to get one 😀