Dessert Pigeon Kit (Build-it-yourself). 3D printed Dessert Pigeon blaster, designed and engineered by MrHeathPants. This kit does NOT include a magazine, battery or charger. This is a DIY kit. Sanding on the parts will be required.
Muzzle and trigger are orange by default.
-Pivoting magazine release
-Semi auto with no rev switch
-Custom pusher design
-Working locking back slide with slide lock and release
-Powered by FlyWheel the World mini flywheels
-High tolerance steel dowel pin for smooth mag release function
-For left handed controls, leave a note on your order
-Compatible with Katana-style magazines and most half-length darts
-Honeybadger motors running on 3s
-Works with most 3s batteries
-19x 3d printed parts in PLA
-2x Honeybadger motors with mounting screws
-21A clone switch
-XT-60 connector pair
-Toy screws for shell and smaller screws for mounting springs
-2x FTW microflywheels
-10″ Red 18AWG silicone wire
-10″ Black 18AWG silicone wire
-Mag release spring
-Mag release dowel pin
WHAT YOU NEED ASIDE FROM THE KIT:
-3s 950mAh or 1000mAh pack 50C or higher (use lower rated packs at your own risk)
-Soldering iron and Solder
-Basic tools (Wire strippers, helping hands, #0/1 screwdrivers, sand paper)
-Safety glasses (for soldering)
Katana Magazines (or similarly sized):
Disclaimer: Ordering all black parts (or even black slide with handle) may make the blaster look very similar to a rear firearm. Use at your own risk.
– Merlin motors produce less heat and spin up faster than HoneyBadgers. Performance is similar to Honeybadger motors with the difference being Merlin motors are able to sustain a longer rev without heating up and are less likely to burn out if a jam occurs.
Original Design by MHPArms on Thingiverse. Used with permission. A percentage of all sales of this item will go to MHPArms.
*sanding/post-processing required in order to achieve smooth function
There are no reviews yet.