Select-Fire Woozi Build Guide

SELECT-FIRE WOOZI BUILD GUIDE

Troubleshooting Tips:

*If Burst is inconsistent, gear might not be hitting inside switch. Make sure inside switch is being pushed. If pusher isn’t retracting all the way, make sure side switch is being pushed. Bend lever so it’s a little longer.

If you plug in battery and pull trigger and the select-fire board bursts into flames, check resistance on motor shaft. If the motor shaft is tight and does not spin freely, it can cause board to blow due to the motor trying to pull more amps than board can supply.

The resistance on the motor shaft is caused by damaging motor during installing gear. Be careful when installing gear, and test gear to make sure it spins smoothly.

Leave a Reply

Your email address will not be published. Required fields are marked *